INFCTRA - Factory Default Settings

Factory Default Values (Table 12-1)

S1-1	Closed	Excitation output is set to 5.0 V
S1-3	Open	High hystersis = 1.5 V
S1-4	Closed	Threshold is shifted to positive
S1-5	Open	No low pass filter
S1-6	Open	No pull-down resistor
S1-7	Open	243K pull-up to +excitation
S1-8	Open	Trigger edge = Negative (high to low transition)
S1-9	Open	No signal is internally connected to the input
S1-10	Open	Twice the line frequency/blank is not grounded
S2-C	Installed	Only "An LO" and "An HI" are locked-out
S3-A	Installed	Enables front-panel buttons
S4-A	Installed	Enables RECALL buttons
S5-A	Installed	Select for excitation output. You may program 5, 8.2 or 12.4 V

Configuration Defaults (Table 12-2)

FEATURE	DEFAULT DESCRIPTION
Operating Mode (Function)	Rate
Scale	Operating Mode (Function) Rate Scale Multiply by 1.00000
Offset	0.00000
Decimal Point	Fixed decimal point: FFFFFF
Setpoints	HI = 10000. LO = 10
Configuration	6 digit display. Each digit may be 0 (default) or 1. Configuration is detailed below.

6 Digits of Configuration
0	0	0	0	0	0
0 1	Enables analog output (4-20 mA) Enables analog output (0-10 V)
	0 1	Unlatched alarm Latched alarm
		0 1	Do not change low alarm Change low alarm to high
			0 1	Message handshake Character handshake
				0 1	9600 baud rate 1200 baud rate
					0 1	Send alarm status character Do not send alarm status character

Home TOC Back